Visonic POWERMASTER-10 Betriebsanweisung PDF herunterladen (Seite 63)

APPENDIX A. PARTITIONING

62 D-303223 PowerMaster-10 / PowerMaster-30 User's Guide

Show Single Partition

In Ready mode, press

and then press the partition number. The display will show information relevant to

the selected partition. Press repeatedly to view memory / status content

Note: After 5 seconds of no button press there will be a timeout and the display will revert to the all partition

display.

Siren

A partition is alarmed when receiving an event from an alarmed device assigned to that partition. Alarmed

devices do not affect partitions to which they are not assigned. A siren is common to all partitions; therefore, an

alarm from one or more partitions will activate the siren.

Siren Activity

• The siren will be activated when receiving an event from an alarmed device.

• Overlapping siren activations from different partitions will not cause the duration of the siren to be

extended.

• When the siren sounds, it will not stop until all alarmed partitions are disarmed. However if the siren is

active due to an alarm from a common area zone, and one of the partitions assigned to this area disarms

the system, the siren will also stop. In case that the alarm is initiated from a common area but continues

with zones that are not assigned to a common area, the siren will not stop until all partitions assigned to

the alarmed zones are disarmed.

• In case that there is a fire in partition 1 and a burglary in partition 2, the siren will sound FIRE. When

partition 1 is disarmed the siren will sound BURGLAR for the remainder of the siren timeout period.

Partition Status display

Partitions status is indicated in the following manner:

P1:X P2:X P3:X

Each X value indicates a different partition state, as follows:

R Ready

N Not ready

A Away

H Home

E Exit delay

D Entry delay

- Not used

KP-140 PG2/ KP-141 PG2

The wireless remote commander is used to control a partition.

Arming/Disarming a Partition

Note: Before using Partitioning, make sure it is enabled in the control panel (see PowerMaster-10 /

PowerMaster-30 Installer Guide).

To arm/disarm a partition, press the desired partition number ( / / ) then perform the arming

action by pressing the (HOME) / (AWAY) / (DISARM) button within a timeout period followed

by the user code.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 75 76

Keine Kommentare

Visonic POWERMASTER-10 Betriebsanweisung Seite 63