Visonic AMBER SELECT Betriebsanweisung PDF herunterladen (Seite 33)

Data Table Details ___________________________________________________________ 6-3

No Activity Time - Determines the time limit for reception of signals from sensors used to

monitor the activity of the sick, elderly, or handicapped. If no device detects and reports

movement at least once within the defined time limit, a 'not-active' alert will be initiated.

Options: 3 Hours, 6 Hours, 12 Hours, 24 Hours, 48 Hours, 72 Hours or Disable.

6.5 Communications Definitions

Communications Definitions enables you to set the telephone communication parameters to

the requirements of the particular Site.

Autotest Time – The time interval between consecutive tests of the telephone line. Options: 1

day, 5 days, 7 days, 30 days or Disabled.

Autotest cycle –The time interval between consecutive telephone line test messages sent to

the central station. The control panel performs this at regular intervals to verify proper

communications. Options: 1 Day, 5 Days, 7 Days, 30 Days or Disabled.

Area Code – The system tel. area code (up to 4 digits).

Out Access Number – The number that is used as a prefix to access an outside telephone line

(if exists).

Central Station Emergency Tel. No. – The telephone number of the central station (including

area code, 16 digit max) to which the Amber Basic PC Remote Programmer will report

events.

Emergency Report Account No. – The number that will identify your specific alarm

control system to the central station. The number consists of 6 hexadecimal digits

Central Station Maintenance/Alarm Tel. No. – The telephone number of the central station

(including area code, 16 digit max) to which the Amber Basic PC Remote Programmer will

report alarm and non-alarm events.

Report Format – The format by which the control panel will report events to central

stations. Options: Contact ID, SIA, 4X2 1900/1400, 4X2 1800/2300 or Scancom.

4/2 Pulse Rate – The pulse rate at which Amber Basic PC Remote Programmer will send

data to central stations, if any of the 4x2 formats has been selected. Options: 10 pps, 20 pps,

33 pps or 40 pps.

Send 2wv Code – Here you determine whether the Amber Basic PC Remote Programmer

will send two-way voice code to the central station (to switch the central station from data

communication to voice communication state) by using pre-selected SIA or Contact-ID

communication formats only. Options: Send or Don't Send.

Voice Session - Central Stations – Opens a two-way voice session with the central station.

Options: Enable or Disable.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 58 59

Keine Kommentare

Visonic AMBER SELECT Betriebsanweisung Seite 33