Visonic TOWER 20 AM - INSTALLER GUIDE Spezifikationen PDF herunterladen (Seite 2)

2 D-301524

Important! Instruct the user to perform walk test at least once a

week, to verify proper operation of the detector.

C. Place a piece of cardboard on the detector’s front side, to

deliberately mask the optical window. After 2 minutes, the yellow

LED should light (see Table 3) and the alarm control panel should

receive the masking alarm.

D. Remove the masking from the detector’s front side. The LED

should extinguish (after about 30 seconds).

Table 3 – LED Operation

Event / status Indication

Low voltage Red flashing

Warm-up (60sec.) Yellow + Red flashing alternately

Self-test failure Yellow + Red flashing simultaneously

AM detection Yellow ON

ALARM Red ON for 2 sec.

Table 4 – Relay Outputs

Relay Output

Event / status

Trouble Alarm

Complete power failure Open Open

Standby Closed Closed

Low voltage Open Closed

Self-test failure Open Closed

AM detection DIP-SW4 = ON Open Open

AM detection DIP-SW4 = OFF Open Closed

Alarm Closed Open for 2 sec.

3.6 Cover Closure (see Fig. 4, steps 7 - 10)

31 2

Tamper switch

Bracket fastening (3 cable routing options)

Drill

Mark

For wall Tamper switch

Note

The 2 screw holes

enable adjustment

of the bracket on

the wall, if needed

as a result of the

walk test.

Fasten

(3 long screws)

Wiring

Press firmly

to release the

bracket

(2 short

screws)

24-HOUR

TAMPER

ZONE

VDC

ALARM CONTROL PANEL

BURGLAR

ZONE N.C.

TEST

SWITCH

(OPTION)

24 HOUR

TROUBLE

ZONE N.C.

DIP switches

OFF ON

SPARE

Figure 3 - Installation

1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare

Visonic TOWER 20 AM - INSTALLER GUIDE Spezifikationen Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Bewegungsmelder Visonic TOWER 20 AM - INSTALLER GUIDE